Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0uPb84-0000C4C; Fri, 31 May 96 15:49 CDT |
Content-Type: |
TEXT/PLAIN; charset=US-ASCII |
Old-Return-Path: |
|
Date: |
Fri, 31 May 1996 16:54:27 -0400 (EDT) |
Precedence: |
list |
Resent-From: |
|
Message-ID: |
<Pine.SUN.3.91.960531165031.5694A-100000@scfn> |
MIME-Version: |
1.0 |
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
X-Status: |
|
Resent-Message-ID: |
<"QrFLF.0.owG._irhn"@ipc> |
Subject: |
|
From: |
|
X-Loop: |
|
In-Reply-To: |
<Pine.SUN.3.91.960531145609.4408A-100000@scfn> |
From [log in to unmask] Wed Jun 5 16: |
25:05 1996 |
Resent-Sender: |
|
Parts/Attachments: |
|
|
I apologize for sending out the earlier message with the last sentence
incomplete...
> I have a requirement to enclose an 8.0"x5.50"x0.062" circuit card
> assembly (CCA). I'm looking for a ABS plastic (preferred) or metal
> "off-the-shelf" enclosure to house this product. CCA connectors & status
> LED's are located on both 8.0" sides of the CCA. Consequently, enclosure
> openings must coincide with the 8.0" CCA dimension. Custom front/rear
> panels are required for connectors/LED's. CCA outline/mounting hole
> locations are subject to enclosure design. Would prefer a slightly larger
> enclosure than smaller (based on 8.0"x5.50" outline). I would
appreciate any leads to suppliers who have products that may fill this
need. Thank you.
>
|
|
|