 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0uPaIR-0000CXC; Fri, 31 May 96 14:55 CDT |
| Content-Type: |
TEXT/PLAIN; charset=US-ASCII |
| Old-Return-Path: |
|
| Date: |
Fri, 31 May 1996 16:01:06 -0400 (EDT) |
| Precedence: |
list |
| Resent-From: |
|
| Resent-Sender: |
|
| MIME-Version: |
1.0 |
| Status: |
O |
| X-Mailing-List: |
|
| TO: |
|
| Return-Path: |
<TechNet-request> |
| X-Status: |
|
| Resent-Message-ID: |
<"LkbTX2.0.CWJ.-wqhn"@ipc> |
| Subject: |
|
| From: |
|
| X-Loop: |
|
| From [log in to unmask] Wed Jun 5 16: |
22:05 1996 |
| Message-ID: |
<Pine.SUN.3.91.960531145609.4408A-100000@scfn> |
| Content-Transfer-Encoding: |
QUOTED-PRINTABLE |
| Parts/Attachments: |
|
|
I have a requirement to enclose an 8.0"x5.50"x0.062" circuit card
assembly (CCA). I'm looking for a ABS plastic (preferred) or metal
"off-the-shelf" enclosure to house this product. CCA connectors & status
LED's are located on both 8.0" sides of the CCA. Consequently, enclosure
openings must coincide with the 8.0" CCA dimension. Custom front/rear
panels are required for connectors/LED's. CCA outline/mounting hole
locations are subject to enclosure design. Would prefer a slightly larger
enclosure than smaller (based on 8.0"x5.50" outline). I would appreciate
hZ_ã'îe
|
|
|
