Hi Gary,
Name here is John Burton, we use the Veribest Software, are in the mode of
moving from Intergraph ATD (unix platform) over to Veribest.  I am not up to
speed on the Veribest yet, but can tell you how we handle our arrays / panels.
It is the same as you now do in Pcad, that is we provide a gerber file showing
how we want the PCB's to  appear in the panel, it only shows the board outline
and the location of the board orgin and the size of the panel.  We send gerber
information for one board and the PCB manufacture then steps and repeats this
for the panel.  We also sent the nc drill information along with the gerber
data.

I know that most gerber tools allow one to do panels, but so far this has been
the best approach for us.  Hope this helps, good luck. 

****************************************************************************
* The mail list is provided as a service by IPC using SmartList v3.05      *
**************************************************************************** 
* To unsubscribe from this list at any time, send a message to:            *
* [log in to unmask] with <subject: unsubscribe> and no text. *
****************************************************************************