The following question is one that was provided by designers for
the  A  basic level exam. It is NOT included in the final published
test and is for reference only. The topic is Copper Features..
     *************************************************************
     
     107  How many component leads can be mounted in any one hole
          used for attaching the component to the circuit pattern?

          A.   one lead
          B.   no more than two leads
          C.   no more than three leads                
          D.   no more than four leads

                              select the most correct answer

          *********************************************************
Previous QOD

     106  Proper tooling hole systems consist of a certain number
          of holes which are positioned in certain locations on the
          board. What are their characteristics?

          D.   a specific number and location to facilitate the
               assembly operation
          
     Resource: IPC-T-50 Specific Terms and IPC-D-275 para 3.3.5;
     6.5;  table 6.2
          *********************************************************

Please send comments, constructive critique, or suggestions to Lisa
Williams at [log in to unmask] 

Dieter Bergman