HELP! HELP! I am looking for information, i.e. articles, publications of any
kind and/or
general feed back regarding bare board repair/re-working trends and overall
attitudes.

I am not looking for specific technical information regarding re-work, rather
what is going on in the industry.  I specifically am interested in finding
out if the industry (over the past 5 years or so) is doing more or less of
the following: 

A.  Fixing surface shorts.
B.  Welding surface opens
C.  Drillingl internal shorts

Also feed back on:

A.  Type of equipment most preferred
B.  Is re-work being sent out or done in house more often (or not done at
all)

Additionally, I would be interested in any personal experiences regarding
this field.

Thank you very much for your help.

Sincerely,


Mark Dragan
HV Test, Inc.