Subject: | |
From: | |
Date: | Sat, 27 May 1995 19:30:28 -0500 (CDT) |
Content-Type: | TEXT/PLAIN |
Parts/Attachments: |
|
|
It is not completely clear from your message as to whether you are asking
about thickness requirements or actual plating deposit requirements.
IPC-RB-276 (Performance spec for printed boards) does have thickness
requirements based on performance class for both nickel and gold
deposits. There is a federal standard on gold referenced, and I believe
one on nickel as well. IPC does not have equivalents of these federal
standards.
Regards
***************************************************
David W. Bergman, Director of Technical Programs
IPC
7380 N. Lincoln Avenue
Lincolnwood, IL 60646
708-677-2850 x340 Phone
708-677-9570 Fax
email [log in to unmask]
***************************************************
On Thu, 25 May 1995, Joseph L Gangemi wrote:
> >From jlg Thu May 25 13:28:31 1995
> From: [log in to unmask] (Joseph L Gangemi)
> Content-Length: 742
>
> I have been researching the various standards for Nickle/Gold requirements and have
> found a wide variation in the Nickle/Gold processes.
>
> Is there an IPC specification for nickle/gold plating??
>
> Any info would be greatly appreciated.
>
> Thanks,
>
> **********************************************************************
> * Joe Gangemi <----> email: hocpa!jlg *
> * Internet <----> [log in to unmask] *
> * AT&T Consumer Products <----> *
> * Wireless Development Lab <----> (908)-834-1377 *
> * Mail Stop 1J-513 <----> Fax (908)-834-1696 *
> **********************************************************************
>
>
>
|
|
|