Subject: | |
From: | |
Date: | Mon, 27 Nov 95 08:36:04 EST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Al--
I beleive that you may be in violation of MIL-STD-275E section 5.6.4
depending on you plating requirements. Along with that, it is also important
to consider the physical location of the pwb with respect to the end
product - is the chassis, casting, etc in physical contact with the the
plane, and is there any electrical problems??? IMOA, cut the plane back from
the edge of the board-- end of story!!
Bob Vanech [log in to unmask]
|
|
|