Subject: | |
From: | |
Reply To: | |
Date: | Mon, 3 Dec 2018 17:00:53 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Ben,
That's a term I haven't heard in a long time!
Wire wrapped terminations were developed by AT&T many many years ago. Gardner Denver made the wire wrap tool I have. Computer backplanes (e.g. Digital Equipment Co). The wire (30ga is what I typically used) was silver plated.
See https://en.wikipedia.org/wiki/Wire_wrap
When I worked at Comsat Laboratories in Clarksville, MD I built very high frequency (500MHz?) circuits for satellite communications with MECL ICs (using twisted pairs of wires with 50 ohm terminations were developed by Motorola for Comsat. The Tek oscilloscope I used for troubleshooting had a sampling plug-in as standard oscilloscopes at that time (1970s)did not have the bandwidth.
See https://en.wikipedia.org/wiki/Emitter-coupled_logic
Beginning in the early 1960s, ECL circuits were implemented on monolithic integrated circuits and consisted of a differential-amplifier input stage to perform logic and followed by an emitter-follower stage to drive outputs and shift the output voltages so they will be compatible with the inputs. The emitter-follower output stages could also be used to perform wired-or logic.
Motorola introduced their first digital monolithic integrated circuit line, MECL I, in 1962.[18] Motorola developed several improved series, with MECL II in 1966, MECL III in 1968 with 1-nanosecond gate propagation time and 300 MHz flip-flop toggle rates, and the 10,000 series (with lower power consumption and controlled edge speeds) in 1971.[19] The MECL 10H family was introduced in 1981.[20] Fairchild introduced the F100K family.[when?]
Here's pictures of some of the Gardner-Denver wire wrap tools
https://www.ebay.com/p/Gardner-denver-Model-14XA2-Electric-Wire-Wrap-Tool/1971302306
I would guess AT&T Bell Labs would have the documentation on testing as I think that's where the technology was developed.
Bob Landman
President
Life Senior Member, IEEE
H&L Instruments, LLC
PO Box 580
34 Post Road
North Hampton, NH 03862
tel (603) 964-1818
www.hlinstruments.com
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Gumpert, Ben
Sent: Monday, December 03, 2018 4:44 PM
To: [log in to unmask]
Subject: [TN] Wire wrapped terminations
TechNetters,
Is anyone familiar with what I'll call 'wire wrapped terminations'?
Such as:
https://www.mouser.com/ProductDetail/Coiltronics-Eaton/CTX300-4-R?qs=yzwxPInThYQ4vFyw6jLRIQ%3D%3D
http://www.vishay.com/docs/34069/lpt4545.pdf
https://products.pulseelex.com/product-details/p0926nl/163/
A request came up at the last J-STD-001 committee meeting for solder joint criteria on these types of terminations, but without any suggestions.
I can't find anything from the vendors for a recommendation. Does anyone know of any testing done with these parts, or know of some recommended solder joint criteria?
Ben
|
|
|