<Engineering canned response #1>
"It depends."

How thick your board?
What volumes you running?  NPI_QTA onshore? Production offshore?
Commodity like super price sensitive pwb fab or high end *BUTS fab?

dw

*
Big
Ugly
Thick
Suckers


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Frank Kimmey
Sent: Tuesday, May 1, 2018 2:55 PM
To: [log in to unmask]
Subject: [TN] Small slots

How narrow a plated slot can be done without premium?
I realize this is very objective but my bosses want some number.
They won't be satisfied with what my vendor says unless I can back it up I'm thinking 0.5 mm but would like to know what others think Any help is appreciated, FNK

Frank N Kimmey CID+
Electrical Engineer/PCB Design

Verifone
1400 W Stanford Ranch Road
Rocklin, CA 95765
T: 916-625-1818
M: 916-833-9877

*********************************************************
This electronic message and any attachments are intended only for the use of the addressee. The information in this electronic message is confidential and proprietary, and may include privileged information. If you are not the intended recipient, please delete this electronic message and any attachments and notify the sender of the error. Please be aware that any unauthorized use, dissemination, distribution or copying of this message or any attachments is strictly prohibited.