Hello council..! Hope all are doing well in the land of PCB design..! Just wanted to check on users of "Mentor Graphic Expedition... How do YOU like this tool... As a new user I'm finding that the simple thing and or trivial things are no producible and or don't perform as one would think from a PCB designer's standpoint... one issue, no smart .pdf from the layout side and or "FabLink"..? also rule setting parameters for trace widths , min, target, max... if your trace isn't to one of these specific numbers in these setting you get a warning..? WOW, rather than a range within the min-max, like PADS... What is your experience with this tool..?





This e-mail message and all attachments transmitted with it may contain legally privileged and confidential information intended solely for the use of the addressee. If you are not the intended recipient, you are hereby notified that any reading, dissemination, distribution, copying, or other use of this message or its attachments is strictly prohibited.



---------------------------------------------------------------------------------

DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.

To unsubscribe, send a message to [log in to unmask] with following text in

the BODY (NOT the subject field): SIGNOFF DesignerCouncil.

To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)

For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815

---------------------------------------------------------------------------------