Well Victor, if Technet cannot answer your question, your next step would
be to pose the question to IPC Staff, such as John Perry, who is very
involved with the IPC-6012 and associated board efforts.  He can then
direct your questions to the Leadership of A-600 for a response.  That's
what this old dinosaur would do....


Doug Pauls
Principal Materials and Process Engineer
Rockwell Collins

On Thu, Mar 8, 2018 at 7:49 AM, <[log in to unmask]> wrote:

> Fellow TechNetters:
>
>    I did not receive responses to my initial inquiry.   Therefore, I post
> once again.   IMHO, Industry Standards are so convoluted that it takes a
> dinosaurs to interpret the documents much less draw correlation between the
> documents.
>
> Victor,
>
> From: Hernandez, Victor G
> Sent: Monday, March 5, 2018 12:37 PM
> To: 'TechNet E-Mail Forum' <[log in to unmask]>
> Cc: Hernandez, Victor G <[log in to unmask]>
> Subject: TM-650-2.1.1; 2.1.1.2 & 2.6.8
>
> Fellow TechNetters:
>
>    What is the purpose of IPC-A-600 (J) if this standard document  is not
> stated/mentioned/referenced in the above TMs.
>                 2.1.1      section 5.4.3   Quality Observations,
> etc..............
>                 2.1.1.2  section 5.2.3   Evaluation, etc..........
>                 2.6.8      section 5.7.2   Examine for compliance,
> etc.......
>
> Is there a separate document for NEW Laminate Qualification.
>
> Victor,
>