Subject: | |
From: | |
Reply To: | |
Date: | Thu, 1 Feb 2018 15:23:40 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Blair,
We normally use dowel pins for fixtures here. Try someone like Grainger item # 5EEG7 seems right. This size has limited options so they are a little expensive.
Regards.
Jerry
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Blair Hogg
Sent: Wednesday, January 31, 2018 2:28 PM
To: [log in to unmask]
Subject: [TN] Tooling / Locating Pins
Hi Technetters,
I'm dipping into the well of knowledge again, hoping someone may have a decent source for tooling or locating pins for holding a PC board on a fixture. I'm typically looking at pins for test fixturing, of various sizes - #4 clearance holes, #6 clearance holes, however, the specific size that I'm looking for currently would be to use with a #4 threaded nut insert, roughly 0.075" to 0.080". Has anyone run across a good source for these types of pins?
Thanks,
Blair
|
|
|