I sure hope there are some flex folks out there today.
I need to know which would likely be cheaper in large quantities:

A: 2 layer with 2 mil wide traces
B: 3 layer with 4 mil wide traces

I guess the big question is what kind of premium should be expected when asking to etch to 2 mils
Any and all help is appreciated.
Thanks,
FNK

Frank N Kimmey CID+
Electrical Engineer / PCB Design
VeriFone Inc
1400 W Stanford Ranch Road, Suite 200
Rocklin, CA 95765 USA
W: 1-916-625-1818
M: 1-916-833-9877
[log in to unmask]

*********************************************************
This electronic message and any attachments are intended only for the use of the addressee. The information in this electronic message is confidential and proprietary, and may include privileged information. If you are not the intended recipient, please delete this electronic message and any attachments and notify the sender of the error. Please be aware that any unauthorized use, dissemination, distribution or copying of this message or any attachments is strictly prohibited.