TECHNET Archives

September 2017

TechNet@IPC.ORG
Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
PCB hole wall Roughness
From:
Deng RongJun <[log in to unmask]>
Reply To:
TechNet E-Mail Forum <[log in to unmask]>, Deng RongJun <[log in to unmask]>
Date:
Wed, 6 Sep 2017 09:54:04 +0000
Content-Type:
text/plain
Parts/Attachments:
text/plain (10 lines) 
Fellow TechNetters:

IPC DR-572A 9.3.3 has defined that the maximum allowable roughness is recommended to be 25 ìm. Is this for all size drilled holes? 
Sometimes I head from PCB fabricator that the drill hole roughness is depends on hole size, ex.: 0.5-0.8mm drill hole roughness <25.4 ìm, 0.8-2.6mm drill hole roughness <30 ìm.
The hole wall roughness will cause blow hole in solder joint during wave or selective soldering if moisture go in to PCB inside. So we need to control the roughness on hole wall surface.
Is anyone have experience on this?   What roughness is reasonable for PCB hole?

Best regards
Deng

ATOM RSS1 RSS2