Femto second laser would be the best... check for bio-medical device
maker... they use fancy substrates cutter... (nano second laser
works, but side wall a bit rough - if you don't care about edge
plating, it would be no issue. imho. for thin substrate like you
posted, diamond machine cutter might be good. Did you talk to the
substrate maker? (if you want to cut funny shape, laser would be the
best bet).
On Sep 25, 2017, at 4:04 AM, John Burke wrote:
>
>
>
>
>
> Agreed I would think laser since you can dice silicon with
> it ...not too sure what wavelength you would need for that though
>
>
> Sent from my iPad Pro
>
>
>
>
>
>
> On Mon, Sep 25, 2017 at 3:58 PM +0800, "Peter Barton"
> <[log in to unmask]> wrote:
>
>
>
>
>
>
>
>
>
>
> Laser?
>
> -----Original Message-----
> From: TechNet [mailto:[log in to unmask]] On Behalf Of TechNet
> automatic digest system
> Sent: 23 September 2017 06:00
> To: [log in to unmask]
> Subject: TechNet Digest - 18 Sep 2017 to 22 Sep 2017 (#2017-153)
>
> There is 1 message totaling 42 lines in this issue.
>
> Topics of the day:
>
> 1. Thin alumina substrate cutter
>
> ----------------------------------------------------------------------
>
> Date: Fri, 22 Sep 2017 18:09:21 +0000
> From: Ioan Tempea
> Subject: Thin alumina substrate cutter
>
> Dear Technos,
>
> I need to cut some narrow strips out of 0.005" thick microstrip
> alumina substrates. The diamond tips we have do an acceptable job
> on the substrate, but tend to lift the corners of the 50 ohms trace.
>
> Is there any special tool for this kind of surgery?
>
> Thanks,
>
> Ioan Tempea, P. Eng.
> Senior Manufacturing Engineer, Satellite Systems
>
> [cid:[log in to unmask]]
>
> MacDonald, Dettwiler and Associates Corporation, 21025 Trans-Canada
> Highway, Ste-Anne-de-Bellevue, QC, Canada H9X 3R2
> Tel: +1-514-457-2150 x3556
> www.mdacorporation.com
>
> This e-mail, and any attachments, are intended solely for the use
> of the intended recipient(s) and may contain legally privileged,
> proprietary and/or confidential information. Any use, disclosure,
> dissemination, distribution or copying of this e-mail and any
> attachments for any purposes that have not been specifically
> authorized by the sender is strictly prohibited. If you are not the
> intended recipient, please immediately notify the sender by reply e-
> mail and permanently delete all copies and attachments. This email
> is for informational purposes only and shall not be interpreted to
> authorize or conclude a binding agreement between MDA and any other
> party unless this email contains or is accompanied by an express
> written confirmation of MDA's intention to enter into a binding
> agreement, such confirmation shall only be provided by an
> authorized representative of MDA.
>
> ------------------------------
>
> End of TechNet Digest - 18 Sep 2017 to 22 Sep 2017 (#2017-153)
> **************************************************************
|