Subject: | |
From: | |
Reply To: | |
Date: | Fri, 16 Dec 2016 07:11:57 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Mike - the general consensus is that there is an issue with the nickel
plating layer. Not a ton of data in the published literature but a topic
that has been discussed a length in the IPC-JSTD-002/003 committees at
times.
Dave Hillman
Rockwell Collins
On Thu, Dec 15, 2016 at 7:53 PM, Lehmicke, Michael <
[log in to unmask]> wrote:
> What is the root cause of Black Oxide issues in ENIG plating?
>
> Mike Lehmicke
> Project Engineer
> DSS Division
> Molex, LLC-Printed Circuit Solutions
> 22 Empire Drive
> St. Paul, MN 55103
> 651-846-7728
> [log in to unmask]<mailto:[log in to unmask]>
>
> [cid:[log in to unmask]][cid:[log in to unmask]]<
> http://www.molex.com/>
>
>
> ________________________________
>
>
>
> CONFIDENTIALITY NOTICE: This message (including any attachments) may
> contain Molex confidential information, protected by law. If this message
> is confidential, forwarding it to individuals, other than those with a need
> to know, without the permission of the sender, is prohibited.
>
> This message is also intended for a specific individual. If you are not
> the intended recipient, you should delete this message and are hereby
> notified that any disclosure, copying, or distribution of this message or
> taking of any action based upon it, is strictly prohibited.
>
> English | Chinese | Japanese
> www.molex.com/confidentiality.html
>
|
|
|