Subject: | |
From: | |
Reply To: | |
Date: | Tue, 20 Dec 2016 07:32:45 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Preheating of the area (PTH) is the key factor to achieve the soldering requirement
________________________________
From: Riccardo Inverardi <[log in to unmask]>
Date: 20 December 2016 at 2:47:15 PM SGT
To: [log in to unmask] <[log in to unmask]>
Subject: [TN] R: [TN] Vertical fill of solder in Supported Holes
Hi Deng, my first ever answer on TN:
You should take a look to IPC-A-610F-AM1 (Dec 2015), where (if memory
doesn't fails me) it is stated that the minimum vertical fill for components
with less than 14 pins, but with a connection to an inner thermal plane is
50%, provided that a 360° lead-to-barrel wetting is present in the solder
source side.
Have a nice day,
--
Riccardo Inverardi
INTEA ENGINEERING
-----Messaggio originale-----
Da: TechNet [mailto:[log in to unmask]] Per conto di Deng RongJun
Inviato: marted́ 20 dicembre 2016 03:01
A: [log in to unmask]
Oggetto: [TN] Vertical fill of solder in Supported Holes
Hi all:
There have a big difference on Vertical fill of solder between
IPC-A-610/J-STD-001 E version and F version. In the F version said that
Vertical fill of solder for component with less than 14 leads is 75%, and
Vertical fill of solder for component with 14 leads or more is 50% for class
2. But in some case some holes connect to ground plane in many layers, they
are very difficult to get 75% vertical fill during wave soldering or hand
soldering.
My question are:
How to improve the process to increase vertical fill from 50% to 75% in
through holes which connect to many layers?
Why IPC do this change? Why IPC define 14 leads, but not 8 leads or 16
leads?
Best regards
Deng
|
|
|