TechNetters,
Can someone measure one of the actual test patterns of a B-24 board and let
me know:
1) the "height" from the outside edge of the thick trace from which the
copper fingers extend "down" to the outside edge of the corresponding thick
trace at the "bottom" of the test pattern. 
2) The width of the pattern from the outside edge of the left-most
"vertical" thin trace to the outside edge of the right-most "vertical" thin
trace.

Thanks in advance.

Regards,
Bev

PS: Results in millimeters (to the nearest half millimeter should suffice)
would be nice. SI is not a Communist plot to overthrow the US. :)