Correct.  An interesting lesson in clarity or lack of it.  I like the quote from someone on TechNet a few years back, referring to a former manager who had degrees in chemistry and English and who had a plaque on his desk saying (approximately), "It is not sufficient that we write in such a way that we can be understood. We must write in such a way that we cannot possibly be misunderstood."  

Thanks to Denny, Tom and Steve for their good information. I knew the foil people had been working on roughness measurements, and any input from that corner was likely to be more than enough for my needs. Zygo and Tencore I had heard of, but never used and had forgotten.
Louis

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of John Burke
Sent: Thursday, July 28, 2016 11:56 AM
To: [log in to unmask]
Subject: Re: [TN] surface profiling

I think Louis was referring to profiling of board topography??

Best regards,

John Burke
 

> On Jul 28, 2016, at 8:53 AM, Nutting, Phil <[log in to unmask]> wrote:
> 
> The last time (several years ago) I bought a unit it as a SLIM KIC 2000.
> 
> Check into www.kicthermal.com
> 
> Phil
> -----