TECHNET Archives

July 2016

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Bob Wettermann <[log in to unmask]>
Reply To:
TechNet E-Mail Forum <[log in to unmask]>, Bob Wettermann <[log in to unmask]>
Date:
Wed, 6 Jul 2016 04:43:01 -0500
Content-Type:
text/plain
Parts/Attachments:
text/plain (37 lines)
Just like BGAs we have found success with small weights (pieces of
stainless or coins) if such bowing happens.

You have to make sure it is no too much weight else you will solder shorts.

Bob Wettermann

On Wed, Jul 6, 2016 at 1:39 AM, Deng RongJun <[log in to unmask]> wrote:

> Hello fellow Techies,
>
> I have got a problem with shielding cans deformation issue. There are
> several kinds of shielding cans on board, we have found one shielding have
> deformation after reflow, one side of shielding lift and not solder on
> board.
> We also do a test, bake the individual shielding in oven with 230 degree,
> the shielding still have deformation and two corner have lift. Take out the
> shielding from oven and temperature go down, then shielding go back to good.
> Any one of you have experience on this case?
>
> Pictures:
> https://goo.gl/photos/xQLbFT1AEwTR2iV68
>
> Thank you very much.
>
> Best regards
> Deng
>



--
Bob Wettermann
BEST Inc
[log in to unmask]
Cell: 847-767-5745

ATOM RSS1 RSS2