We purchased our MVP AOI inspection system with this being one of the functions we wanted to perform. With the programmable Z-axis it works extremely well. We treat each of the tops of the pins as if it was an 001002, and look for any more than .0015" off from a reference pin. It finds the bent pins every single time. I am continually amazed at the number of things we can automatically inspect with this machine, and we have had it for about 5 years now. Very, very happy with MVP!  https://www.youtube.com/watch?v=4ahhtgQBZ8I


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Deng RongJun
Sent: Monday, May 09, 2016 7:34 AM
To: [log in to unmask]
Subject: [TN] Press-fit inspection

Dear Technos,

How to inspect pin slant after pin insert in to PCB hole by auto-insert machine? The requirement of slant is +/-3 degree. Which kind of machine can do this inspection?


Best regards
RongJun Deng

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________