It depends on the product type. Can you give us a little more info as to what the product is and its typical use environment? Also, is the board conformal coated?

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of pietro
Sent: Wednesday, April 13, 2016 7:49 AM
To: [log in to unmask]
Subject: [TN] adhesive recommendation

Hi.

I'm new to the forum and hope my request make sense.

When using jumper wires on PCB, besides other directives IPC recommend to put adhesive spot at least every 25.4mm.

My basic question: is there any recommendation about what kind of glue/adhesive to use ?

Any suggestion will help.

Thanks

    Pietro



______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
-- 

Pietro Vergine
President

CID Trainer

Leading Edge

Via Delle Attivitá 18

24041 Brembate (Bergamo) - Italy

mobile (+39) 335-5783220

email: [log in to unmask]

internet: www.leading-edge.it

Skype: pietver27

Rispetta l'ambiente: se non ti è necessario, non stampare questa mail.

To respect the environment, if not necessary do not print this email





______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________