Subject: | |
From: | |
Reply To: | |
Date: | Wed, 23 Mar 2016 20:25:05 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
You can add extra paste where needed when a step won't work.
Rework where stencils are difficult or impossible.
On 3/23/2016 3:20 PM, Ahne Oosterhof wrote:
> Just curious, why would you use such a dispenser rather than a stencil?
>
> Ahne.
>
> -----Original Message-----
> From: TechNet [mailto:[log in to unmask]] On Behalf Of Bob Wettermann
> Sent: Wednesday, March 23, 2016 6:55 AM
> To: [log in to unmask]
> Subject: [TN] Auger Driven Dispensers
>
> Gents/Ladies:
>
> We are looking at putting a non-pneumatic drive dispenser on a robot. Due to some pretty fine dots, the need for speed and for consistency and the need for some lines to be dispensed, we are looking at an auger-driven system (5-6 mil dots).
>
> Does anyone have favorite vendors of the dispensing pumps and controllers that can be added on to a pieces of automation equipment?
>
> Regards
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
> --
> Bob Wettermann
> BEST Inc
> [log in to unmask]
> Cell: 847-767-5745
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|