Sender: |
|
X-To: |
|
Date: |
Thu, 18 Feb 2016 18:56:18 -0500 |
Reply-To: |
|
Message-ID: |
|
Subject: |
|
From: |
|
Content-Transfer-Encoding: |
7bit |
In-Reply-To: |
|
Content-Type: |
text/plain; charset="ISO-8859-1"; format=flowed |
MIME-Version: |
1.0 |
Parts/Attachments: |
|
|
Does anyone know what the typical aspect ratio would be for a 6mil
(0.152mm) drill in FR4 would be?
Can a 6mil drill be used as a full drill-thru on 0.062 thick circuit
board? -which I think would be a 10:1 aspect ratio...
I've got a design with a 0.5mm uBGA (169 pin, full array) that i want to
do fanout vias between pads. I'm using a 8.7mil BGA pad and planning on
a fanout via with a 12mil pad and 6mil drill. I originally set this up
as a blind via from top to inner1 layer, which works, but I am quickly
running out of available via room around the BGA for connecting signals,
power/gnd, ect. I'm using an 8mil drill elsewhere on the board which I
know is doable on a 0.062 board -just not sure if 6mil is doable -and
with a 3mil annular ring!
Any advice greatly appreciated.
Thanks
Ron
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|