Never less than 25 mils. That being said, I had to go to 10 mils once but
we paid bucks for it. And always keep traces within the plane area.
On Wed, Jan 6, 2016 at 12:02 PM, Brooks, William <
[log in to unmask]> wrote:
> What do you recommend for clearance from the edge of an internal plane to
> the board edge?
>
>
>
> William Brooks, CID+
> Printed Circuit Designer
> 2747 Loker Ave West
> Carlsbad, CA 92010-6603
> 760-930-7212
> Fax: 760.918.8332
> Mobile: 760.216.0170
> E-mail: [log in to unmask]
>
>
>
> _____________________________________________________________________________
> Scanned by IBM Email Security Management Services powered by MessageLabs.
> For more information please visit http://www.ers.ibm.com
>
> This email is intended only for the use of the party to which it is
> addressed and may contain information that is privileged, confidential, or
> protected by law. If you are not the intended recipient you are hereby
> notified that any dissemination, copying or distribution of the email or
> its contents is strictly prohibited. If you have received this message in
> error, please notify us immediately, by replying to the message and
> deleting it from your computer.
>
> WARNING: Internet communications are not assured to be secure or clear of
> inaccuracies as information could be intercepted, corrupted, lost,
> destroyed, arrive late or incomplete, or contain viruses. Therefore, we do
> not accept responsibility for any errors or omissions that are present in
> this email, or any attachment, that have arisen as a result of e-mail
> transmission.
>
> _____________________________________________________________________________
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
>
>
>
> ---------------------------------------------------------------------------------
> DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
> 16.0.
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
> To temporarily stop/(restart) delivery of DesignerCouncil send: SET
> DesignerCouncil NOMAIL/(MAIL)
> For additional information, or contact Keach Sasamori at [log in to unmask]
> or 847-615-7100 ext.2815
>
> ---------------------------------------------------------------------------------
>
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|