On 4 Dec 2015 at 10:31, Steve Gregory wrote:

> Hi All,

[...]
> So I've been looking around and I'm not looking the buy a seat at a
> full-blown CAD station, just something inexpensive and simple to use. So
> I've been looking at Eagle, and my question is, have any of you used this?
> Is this software a good starting point for a rookie like me? I know there
> is an IPC Designers Council forum, but those guys are so far ahead of me
> that I don't want to waste their time. Any feedback is welcome.

Perhaps you can try free DesignSpark from RS Components, it is quite 
widely used meanwhile and has a good community.

However, if the changes are just some small moves and not a total 
redesign, if this would be my job and I had no CAD software, I really 
would prefer to make these changes within a gerber editor (I use 
Zuken Cadstar for layouts and CAM350 for Gerber checks, panelization 
and sometimes for small changes from customer layouts if I just have 
gerbers and nothing else).

Best regards
Matthias
--
Matthias Mansfeld Elektronik * Printed Circuit Board Design and 
Assembly
Neithardtstr. 3, D-85540 Haar, GERMANY
Phone: +49-89-4620 0937, Fax: +49-89-4620 0938
Internet: http://www.mansfeld-elektronik.de
OpenPGP: http://www.mansfeld-elektronik.de/gnupgkey/mansfeld.asc
Fingerprint: 6563 057D E6B8 9105 1CE4 18D0 4056 1F54 8B59 40EF



______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________