Is this a common solder-mask pattern? I.e. is it a through-hole only board that would have the same soldermask apertures on both sides of the board?
Was it an air-spray or curtain-coat application?
Regards,
James
James Head BEng CID+ MIIE MIET
Senior PCB CAD Engineer
Crowcon Detection Instruments Limited
172 Brook Drive
Milton Park
OX14 4SD
Telephone: +44 (1235) 557700 ext. 7885
E-mail: [log in to unmask]
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________