Subject: | |
From: | |
Reply To: | |
Date: | Wed, 11 Nov 2015 09:08:35 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi James,
This is a mixed technology board, so there is the SMT on the topside along
with the through hole pattern. I don't know how the mask was applied.
Steve
On Wed, Nov 11, 2015 at 4:22 AM, James Head <[log in to unmask]> wrote:
> Is this a common solder-mask pattern? I.e. is it a through-hole only board
> that would have the same soldermask apertures on both sides of the board?
> Was it an air-spray or curtain-coat application?
>
> Regards,
> James
>
> James Head BEng CID+ MIIE MIET
> Senior PCB CAD Engineer
> Crowcon Detection Instruments Limited
> 172 Brook Drive
> Milton Park
> OX14 4SD
> Telephone: +44 (1235) 557700 ext. 7885
> E-mail: [log in to unmask]
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
>
--
This email and any attachments are only for use by the intended
recipient(s) and may contain legally privileged, confidential, proprietary
or otherwise private information. Any unauthorized use, reproduction,
dissemination, distribution or other disclosure of the contents of this
e-mail or its attachments is strictly prohibited. If you have received this
email in error, please notify the sender immediately and delete the
original.
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|