Subject: | |
From: | |
Reply To: | |
Date: | Fri, 2 Oct 2015 12:36:17 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Perhaps you can ask your board fabricator? I would imagine they have methods for doing this. Perhaps also they may be able to do it for you cheaper than you could set yourself up to do it? Doesn't hurt to ask.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez
Sent: Friday, October 02, 2015 6:52 AM
To: [log in to unmask]
Subject: [TN] FW: Solder mask removal, SMOBC
Fellow TechNetters:
I did not receive very much feedback on my initial inquiry. Therefore, I ask again. Additionally I also ask if Solder mask and conformal coating the same Product/Term (IPC-7711.21 section 2.3.1. I want to removal/strip solder mask. At this point I do not known the solder mask vendor or type.
Victor,
From: Hernandez, Victor G
Sent: Thursday, October 01, 2015 10:56 AM
To: TechNet E-Mail Forum
Cc: Hernandez, Victor G
Subject: Solder mask removal
Fellow TechNetters:
I have been asked to see if that is a satisfactory method for removing/stripping solder mask from sample coupons chemically and/or mechanically.
Victor,
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|