Subject: | |
From: | |
Reply To: | |
Date: | Mon, 21 Sep 2015 15:36:45 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Victor,
An unsupported does not have plating - this is all defined in IPC-T-50.
Regards Steve Kelly
On 2015-09-21, 3:29 PM, "Victor Hernandez" <[log in to unmask]>
wrote:
>I did not received any responses, so decide to re-submit.
>
>Victor,
>
>From: Hernandez, Victor G
>Sent: Friday, September 18, 2015 9:14 AM
>To: TechNet E-Mail Forum
>Cc: Hernandez, Victor G
>Subject: Supported & Unsupported holes
>
>Fellow TechNetters:
>
> Is it safe to stated that a SUPPORTED hole contains a plated through
>BARREL and an UNSUPPORTED holes does not contain a plated through
>BARREL... I am measuring the hole break out on an external PTH annular
>ring. IPC-2221 Figure 9-2 & Table 9-2.
>
>Victor,
>
>
>______________________________________________________________________
>This email has been scanned by the Symantec Email Security.cloud service.
>For more information please contact helpdesk at x2960 or [log in to unmask]
>______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|