Hi Adrian,

The TechNet server strips all attachments, but if you want to reply to this
message and send your picture to me I'll post it on my web page so everyone
can see...

Steve Gregory

On Thu, Aug 27, 2015 at 7:27 AM, Adrian Dimulescu <[log in to unmask]>
wrote:

> We are looking at different methods of attaching a pin to a PCB assembly
> but are not sure if it's Class 2 or 3 acceptable.  Per attached picture, we
> want to solder a pin into a plated edge-wrapped slot located at the edge of
> the board.
>
> Does anybody know if this is acceptable per IPC requirements?  I searched
> IPC-610 but couldn't find anything similar to this.
>
> Adrian Dimulescu
> MtronPTI
> [log in to unmask]
> (407) 298-2000 x2263
>

-- 


This email and any attachments are only for use by the intended 
recipient(s) and may contain legally privileged, confidential, proprietary 
or otherwise private information. Any unauthorized use, reproduction, 
dissemination, distribution or other disclosure of the contents of this 
e-mail or its attachments is strictly prohibited. If you have received this 
email in error, please notify the sender immediately and delete the 
original. 


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________