Probably falls in the same category as the precision of the locations of
pads on the board: Whatever the drawing specifies!
Ahne.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bob Lazzara
Sent: Friday, July 31, 2015 11:28 AM
To: [log in to unmask]
Subject: [TN] PCB length/width tolerance
Dear TechNetters:
Can anyone point me in the direction of a standard/reference that defines
tolerance for PCB size (length and width)?
The -2221, Fig. 5-1, shows ± 0.016". This seems quite generous but I can
find nothing else.
Thanks in advance -
Bob Lazzara
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________