Anytime, Doug. I was not sure what size you needed.



From: Douglas Pauls [mailto:[log in to unmask]]
Sent: Tuesday, June 09, 2015 9:13 AM
To: Stadem, Richard D.
Cc: TechNet E-Mail Forum
Subject: Re: [TN] Programmable hoist

Thank you good Sir.  The second one was exactly what I was looking for.


Doug Pauls
Principal Materials and Process Engineer
Rockwell Collins

On Tue, Jun 9, 2015 at 9:09 AM, Stadem, Richard D. <[log in to unmask]<mailto:[log in to unmask]>> wrote:
http://www.glenro.com/conformal-bench.html
https://www.qualtechproductsindustry.com/products/application-series-instruments/dip-coater/


-----Original Message-----
From: TechNet [mailto:[log in to unmask]<mailto:[log in to unmask]>] On Behalf Of Douglas Pauls
Sent: Tuesday, June 09, 2015 9:00 AM
To: [log in to unmask]<mailto:[log in to unmask]>
Subject: [TN] Programmable hoist

Good morning all,

Does anyone know of a good source for a programmable hoist?  I need to do some dip coating of items and it needs to be at a controlled withdrawal rate.  Does not have to hold a lot of weight, so no hoists to lift automotive engines.  A travel of no more than say 18 inches.

Thanks.

Doug Pauls
Principal Materials and Process Engineer Rockwell Collins


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]<mailto:[log in to unmask]> ______________________________________________________________________


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________