Subject: | |
From: | |
Reply To: | |
Date: | Fri, 24 Apr 2015 15:52:26 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Dwight,
OK - these have to be button/selective plated - ever seen that? And we
have to etch .004 spaces after the button plate. Regards Steve
On 2015-04-24, 3:30 PM, "Dwight Mattix" <[log in to unmask]> wrote:
>if you're at the right fab, that can be solid
>copper filled (plated full). We see a lot of
>that used, esp in "core" vias in 2n2 and 3n3 uVia stackups.
>
>A lot of extreme aspect ratio Loadboard and
>Probecard designs use 5 and 6 mil flipdrilled
>thru vias as thick as 5mm overall. Those finish
>after plating in 3-4 mil range at the knee.
>Those (very) select few shops that can fill those
>plated vias up beyond 30:1 aspect ratio with the
>likes of San-Ei and then overplate for socket or probe contacts.
>
>At 07:13 AM 4/23/2015, Steven Kelly wrote:
>>Hi All,
>>Do you think it is feasible to do non-conductive
>>via fill on a .0025- .003 finished hole size ¡©
>>overall thickness is .028. Regards Steve
>>
>>______________________________________________________________________
>>This email has been scanned by the Symantec Email Security.cloud service.
>>For more information please contact helpdesk at x2960 or [log in to unmask]
>>______________________________________________________________________
>
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|