Subject: | |
From: | |
Reply To: | |
Date: | Tue, 17 Feb 2015 15:20:23 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I would say this stuff is quick to "detect" poor technique/tip temp/style
selection. You need a one time quick in and out. Consider pre-tinning leads.
--
Regards
Mike
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Steve Gregory
Sent: Tuesday, February 17, 2015 8:58 AM
To: [log in to unmask]
Subject: [TN] Hand soldering Side Launch SMA RF connector to Rogers 4003C
board
Good Morning,
We may be getting a job here where we have to hand solder a side launch SMA
RF connector to a little board (it's a small radar antenna). It seems pretty
simple. But the board is made of a Rogers 4003C material. I don't remember
ever working with boards made of that. But I do recall that some of these
high frequency materials do have issues with pad adhesion if you're not
careful when you hand solder or rework something. Will we have any issues
with this material? I looked at the spec sheet and it did say not to use a
lot of pressure when soldering.
Steve
--
This email and any attachments are only for use by the intended
recipient(s) and may contain legally privileged, confidential, proprietary
or otherwise private information. Any unauthorized use, reproduction,
dissemination, distribution or other disclosure of the contents of this
e-mail or its attachments is strictly prohibited. If you have received this
email in error, please notify the sender immediately and delete the
original.
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|