Subject: | |
From: | |
Reply To: | |
Date: | Tue, 9 Dec 2014 14:09:44 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Seems like perfect use for a staking adhesive, except for your strange
requirement that it be easily removable. Staking adhesives enhance reliability
by assisting with strengthening the mechanics at the corner balls, and are
known to increase the resistance to shock loads too.
So if you're stuck with this strange set of requirements, then I doubt you'll
find something pre-qualified for it. So since qualification is required,
anything is open game. I'd play with water washable solder masking materials,
also peelable masking material.
Wayne Thayer
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of David Hillman
Sent: Tuesday, December 09, 2014 8:42 AM
To: [log in to unmask]
Subject: [TN] BGA Reflow Issue
Hi gang - looking for an adhesive suggestion. I have an assembly in which a
heavy BGA was accidently located on process side one (bottom) so that when we
reflow process side two (top) the BGA is doing its best to fall off.
Unfortunately I can't reverse my process order for a couple of reasons so I am
looking for a temporary fix until I can get the assembly revised. I was
thinking of using some type of adhesive to temporarily hold the BGA in place
during reflow - tack down the corners sort of action. Does anyone have any
adhesive (ideally temporary, water washable/removable) suggestions I can
investigate?
TIA
Dave Hillman
Rockwell Collins
[log in to unmask]
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|