Subject: | |
From: | |
Reply To: | |
Date: | Mon, 22 Sep 2014 16:22:02 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
correct me if i am wrong. I recall an on line calculator from pcb
vendor provide the line/spacing....
jk
On Sep 22, 2014, at 2:50 PM, Victor Hernandez wrote:
> Fellow TechNetters:
>
> I did not receive a reply so I posted my inquiry again. It's
> Monday so things might be slow! I did review IPC-2221B Table 6-1
> Electrical; Conductor Spacing. I guess if I have drill
> misregistration, as long as it doesn't come closer than 2 mils,
> it's OK! I needs comments and/or suggestions. This inquiry is
> on a cross section method. I will plan to do a flat section later.
>
> Victor,
>
> From: Hernandez, Victor G
> Sent: Monday, September 22, 2014 9:11 AM
> To: TechNet E-Mail Forum ([log in to unmask])
> Cc: Hernandez, Victor G
> Subject: Electrical Spacing, Clearance to PTH copper barrel, IPC-6012C
>
> Fellow TechNetters;
>
> I am searching for info on electrical spacing requirements
> between an internal conductor/Land to PTH copper barrel distance.
> In my case it can be either drill process misregistration and/or
> internal core misregistration. In either case what is the closest
> distance that a conductor/land can be to the PTH copper barrel.
>
> Victor,
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud
> service.
> For more information please contact helpdesk at x2960 or
> [log in to unmask]
> ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|