Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Fri, 8 Aug 2014 11:36:53 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello Gregg,
You can place Via in pad, using a type VII via protection (Filled and capped). For balancing, place via on pad for both the pads of 0805.
Thanks and regards,
Renjith Varughese
-----Original Message-----
From: DesignerCouncil [mailto:[log in to unmask]] On Behalf Of Heather Gregg
Sent: Friday, August 08, 2014 5:01 PM
To: [log in to unmask]
Subject: [DC] Vias in pads
Hello,
It has been a number of years since I was active in the PCB design realm. I was asked a question yesterday about the possibility of placing vias inside a component pad. My first response was "no way", but then I thought maybe things have changed.
I have used vias in heatsink pads for thermal reasons, but this designer was asking about placing a signal via inside one pad of an 0805 resistor.
What are the guidelines these days?
Thanks,
Heather Gregg
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL) For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|