Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Fri, 8 Aug 2014 07:30:38 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello,
It has been a number of years since I was active in the PCB design realm. I
was asked a question yesterday about the possibility of placing vias inside
a component pad. My first response was "no way", but then I thought maybe
things have changed.
I have used vias in heatsink pads for thermal reasons, but this designer
was asking about placing a signal via inside one pad of an 0805 resistor.
What are the guidelines these days?
Thanks,
Heather Gregg
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|