Hi Steven,

The usage is 113 pcs/unit, it's hard to rework under manual rework

Lyon yuan

-----Original Message-----
From: Steve Gregory [mailto:[log in to unmask]]
Sent: Friday, April 4, 2014 10:24 PM
To: [log in to unmask]; lyonyuan
Subject: RE: [TN] Press-fits connector

Hi Lyon,

Don't mean to ask a dumb question, but why would you want to send the whole
board through reflow to rework it for a wrong value resistor?

In my experience it's always been a manual process to rework chip components
with wrong value. Can be a PIA, but it can go pretty quick with the right
solder tip for removal. For example, here's a Metcal tip for 0402's and
0603's:

http://www.okinternational.com/Hand_Soldering_Systems/id-SMTC-596/SMTC_R
ework_Cartridge_Slot__SMTC-596


Steve


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of lyonyuan
Sent: Friday, April 4, 2014 7:03 AM
To: [log in to unmask]
Subject: [TN] Press-fits connector

Hi Guys,



Anyone to know if the material of housing of connector is LCP, if can endure
reflow process? Since we need rework some boards with wrong component for
res we don't want to remove those press fit connectors.



Lyon yuan





______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________



______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________