Hi Lyon,

Don't mean to ask a dumb question, but why would you want to send the
whole board through reflow to rework it for a wrong value resistor?

In my experience it's always been a manual process to rework chip
components with wrong value. Can be a PIA, but it can go pretty quick
with the right solder tip for removal. For example, here's a Metcal tip
for 0402's and 0603's:

http://www.okinternational.com/Hand_Soldering_Systems/id-SMTC-596/SMTC_R
ework_Cartridge_Slot__SMTC-596


Steve 


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of lyonyuan
Sent: Friday, April 4, 2014 7:03 AM
To: [log in to unmask]
Subject: [TN] Press-fits connector

Hi Guys,

 

Anyone to know if the material of housing of connector is LCP, if can
endure reflow process? Since we need rework some boards with wrong
component for res we don't want to remove those press fit connectors.

 

Lyon yuan

 



______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud
service.
For more information please contact helpdesk at x2960 or
[log in to unmask]
______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________