Does anyone have a good solution for "rapid" processing of the Mil grade families of resistors (like the RN55) so the assembler ends up with the value marking always displayed on the top of the part?  I've only ever seen this done on a one-at-a-time basis.  We have a contract that requires being able to read the values and our current method does not meet the necessary volume rate.

Phil Nutting  |  HVP Development Engineer   |  Excelitas Technologies Corp

Office: +1 978.224.4152  |  Lab: +1 978.224.4332
35 Congress St, Salem, MA  01970 USA
[log in to unmask]<mailto:[log in to unmask]>
www.excelitas.com<http://www.excelitas.com/>


[Excelitas R_emailsig]


Please consider the environment before printing this e-mail.
________________________________
This email message and any attachments are confidential and proprietary to Excelitas Technologies Corp. If you are not the intended recipient of this message, please inform the sender by replying to this email or sending a message to the sender and destroy the message and any attachments. Thank you.



______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________