Subject: | |
From: | |
Reply To: | |
Date: | Fri, 21 Feb 2014 09:02:58 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
IMHO Acetone is a bad idea to much risk in damaging the board mask and
substrate. Acetone is used as a solvent for fiberglass resins. I
have stated before we use 200 proof dehydrated, un denatured alcohol.
Use in a well ventilated room. Runs about $750 a gal but lasts a long
time. That included the federal booze tax and Cal. state taxes.
Mildly denatured leaves a residue but will clean, we use that for
stainless steel cleaning. I learned about 200 proof in uncle sams
yacht and canoe club, that was all we were allowed to use. Had to
get it from the doc in minute quantity's.
.pat
On Thu, Feb 20, 2014 at 9:06 AM, Douglas Pauls wrote:
> Bob,
> Too many unknowns to give you a good answer. 1. Why is acetone used
> to wipe down the boards? Bad idea in general.
> 2. What is meant by "boards appeared dirty"? What visual effect is
> being noted? And is this at the bare board level or after some
> processing>
>
> Doug Pauls
>
>
>
> From: Robert DeQuattro <[log in to unmask]>
> To: <[log in to unmask]>
> Date: 02/20/2014 11:01 AM
> Subject: [TN] Acetone as a cleaning agent for PCBA's
> Sent by: TechNet <[log in to unmask]>
>
>
>
> I have a customer that uses acetone to wipe down their PCBA's upon
> receipt.
> The assemblies we make for them are cleaned using a closed loop
> aqueous board washer then sampled for cleanliness with our zero-ion
> tester per J-std-001E guidelines.
> Recently this customer commented that boards appeared dirty upon
> cleaning with the acetone. Does anyone have any thoughts on this
> acetone cleaning process.
> Thanks,
>
> Bob
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud
> service.
> For more information please contact helpdesk at x2960 or
> [log in to unmask]
> ______________________________________________________________________
>
>
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud
> service.
> For more information please contact helpdesk at x2960 or
> [log in to unmask]
> ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|