Hello TechNet Gurus,

 

I would like to ask your recommendation or any thoughts about your
experience with pneumatically operated board support tooling for solder
paste printers.

 

We build double sided densely populated boards and the set-up time for
the 2nd pass takes longer time.

We use the regular pin supports and manually locate them where there are
blank spaces between the components. 

 

The price is expensive for 5 older MPM Accuflex printers and investing
more capital is certainly a question to buy-off these support tooling.

 

Thank you in advance.

 

Best regards,

 

Ernesto

 

Ernesto V. Rueda, CEAS(tm)   |   PELCO by Schneider Electric   |   SMT
Process Engineer
Phone: +1 559-292-1981 ext. 3848  |   Fax: +1 559-388-3781  |   Mobile:
+1 559-333-3913
Email: [log in to unmask]
<mailto:[log in to unmask]>     |   Site:
www.pelco.com
<outbind://161-00000000C80BE5EE08E5D111903400A024D164B80700A3F1CFBD2A32D
0118FCA00A024D164B80000003D2FB10000074F3E4A019C0E428C5726FC9D98267600000
2A0A5720000/www.schneider-electric.com/buildings>    |   Address: 3500
Pelco Way, Clovis, CA  93612-5699 USA
P please consider the environment before printing this email

 


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________