Hi Steve,
WS6536 was initially replaced by DOD-STD-2000 Vol 1,2,and 3; then Mil-STD-2000, and subsequently MIL-STD-2000 revision A, and in some cases Rev B. Commercial Standards like IPC J-STD-001 and the eventual revisions to that document were commonly applied to new requirements after elimination of the Military specifications. Some also went to IPC-A-610 without 001 process control provisions.
Please let me know if I can be of assistance. 

Regards,
Mel




Mel Parrish
FSO, Director Training Materials
STI Electronics Inc.
261 Palmer Rd.
Madison, AL 35758
756 705 5530
[log in to unmask]



        


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Vargas, Stephen M
Sent: Monday, November 18, 2013 7:29 AM
To: [log in to unmask]
Subject: [TN] Standards

Can anyone tell me if the Class 3 requirements of J-STD-001 are comparable to Navy Weapons Specification WS-6536? It appears as though WS-6536 was replaced by MIL-STD-2000, but I'm not 100% sure. Any insight would be appreciated.

Regards,
Steve Vargas

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________