You can use a 5/16" 4-40 cap head screw. Same length but the head is only .030" thick. I have attached a picture. It won't show up on the posting, Steve, but you should get it directly.
dean

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Steve Gregory
Sent: Monday, September 23, 2013 10:19 AM
To: [log in to unmask]
Subject: [TN] Does anybody know where I can get a 5/16" long 4-40 wafer head machine screw?

Morning all,

 

Looking to find a 5/16" long 4-40 thread wafer head machine screw. It's
to fasten down a TO-247 Power Transistor...don't have any clearance for
the screw head. That's why I'm looking for a thin head. I only have
about .053" clearance for the head of the screw.

 

Any help would be appreciated...

 

Steve 

 


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________