Bob,

Using a component counting machine is about the easiest way out there.  They range in cost from $350 to $1500.

Leland

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bob Wettermann
Sent: Wednesday, August 14, 2013 2:20 PM
To: [log in to unmask]
Subject: [TN] Measuring a few parts on cut tape many times over

Dear Technetters:

For those of you doing protos who deal with "cut tape" as a feed in to the feeder is there an easy way to count the number of parts each and every time? It takes a lot of time to count these parts (and it is soooo boring) and then cut the strip to the correct size.

Thanks!

Bob W


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________

________________________________

“Confidentiality Notice:
This transmission (including any attachments) may contain confidential information belonging to the sender and is intended only for the use of the party or entity to which it is addressed. If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution, retention or the taking of action in reliance on the contents of this transmission is strictly prohibited. If you have received this transmission in error, please immediately notify the sender and erase all information and attachments.”

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________