 
| Sender: |
|
| X-To: |
|
| Date: |
Mon, 22 Jul 2013 13:13:33 +0000 |
| Reply-To: |
|
| Message-ID: |
|
| Subject: |
|
| From: |
|
| MIME-Version: |
1.0 |
| In-Reply-To: |
|
| Content-Transfer-Encoding: |
quoted-printable |
| Content-Type: |
text/plain; charset="us-ascii" |
| Parts/Attachments: |
|
|
Perhaps no response because I, for one, do not understand what you are asking. Is the connector not flush to the PWB? Or is there a lifted pad?
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Lyon Yuan
Sent: Saturday, July 20, 2013 7:33 PM
To: [log in to unmask]
Subject: Re: [TN] Regarding on press-fit connector lifted
Any reply?
Lyon Yuan
-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]] On Behalf Of Lyon Yuan
Sent: Saturday, July 20, 2013 7:11 PM
To: [log in to unmask]
Subject: [TN] Regarding on press-fit connector lifted
Importance: High
Hi Folks,
What's the standard on press-fit connector lifted?
Lyon Yuan
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|
