Subject: | |
From: | |
Reply To: | |
Date: | Fri, 21 Jun 2013 11:26:08 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Phil,
I use Barco Bond M-100X as the base, I also will grind up some circuit
board to add to the adhesive to give the fill some board body if the
area is large. There is usually some unused portion of the board that
using a rasp one can obtain enough filler material to do the job to add
it to adhesive. You can also mill out the area, and using a piece of
scrap board mill a patch and epoxy it in place. I have done it both
ways and it depends on the size of the divot.
Pat Goodyear
On Fri, Jun 21, 2013 at 6:20 AM, Nutting, Phil wrote:
> Good morning all,
>
> This is a question regarding the repair of FR-4 after there has been a
> high voltage arc/burn. In a recent failure we ground out all the
> burned material and "repaired" the board with 5 minute epoxy. This is
> on a pancake connector for a 160kV x-ray tube. I am of the opinion
> that 5 minute epoxy will soon fail as it does not have the same
> insulating characteristics as the base FR-4.
>
> I see that Circuit Technology carries all sorts of repair
> materials/kits. So, if you were to salvage a burnt circuit board that
> had to ship right away, what materials would you use?
>
> Off line replies are accepted if you want to protect your sources or
> don't want to "advertise" on Technet.
>
> Thanks in advance for your wealth of information,
>
> Phil Nutting | HVP Development Engineer | Excelitas Technologies
> Corp
>
> Office: +1 978.224.4152
> 35 Congress St, Salem, MA 01970 USA
> [log in to unmask]<mailto:[log in to unmask]>
> www.excelitas.com<http://www.excelitas.com/>
>
>
> [Excelitas R_emailsig]
>
>
> Please consider the environment before printing this e-mail.
> ________________________________
> This email message and any attachments are confidential and
> proprietary to Excelitas Technologies Corp. If you are not the
> intended recipient of this message, please inform the sender by
> replying to this email or sending a message to the sender and destroy
> the message and any attachments. Thank you.
>
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud
> service.
> For more information please contact helpdesk at x2960 or
> [log in to unmask]
> ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|