Look at Diodes Inc ...MMDT3904-7-F family...part mark is K6NY4


On Thu, Apr 25, 2013 at 1:44 AM, Inge Hernefjord <[log in to unmask]>wrote:

> Hi JFB,
>
> Texas Instruments make a sensor chip named K4-111.
>
> Inge
>
>
> On 24 April 2013 21:47, Jean-François Bissonnette
> <[log in to unmask]>wrote:
>
> > K4 is actually written on the IC, and there is many of them on the board,
> > near the connectors.
> >
> >
> > On Wed, Apr 24, 2013 at 1:13 PM, Inge Hernefjord <[log in to unmask]
> >wrote:
> >
> >> A mountain little lower than K2?
> >>
> >> Inge
> >>
> >> PS. sounds more like a component position. Like R4, C4, L4 etc
> >>
> >>
> >> On 24 April 2013 17:35, Jean-François Bissonnette <
> >> [log in to unmask]> wrote:
> >>
> >>> Hi all,
> >>>
> >>> I'm looking for a component that was blown to silicone heaven on a
> >>> commercial IC programmer (Insight Adapter 3).
> >>>
> >>> The marking on the component is K4. I suspected it was an ESD
> protection
> >>> diodes package (PESD05V0L5UY) but the dimensions in the spec don't
> match.
> >>>
> >>> SOT363's pitch 0.65mm but what I'm measuring is closer to 1mm.
> >>>
> >>> Anyone would have an idea on what that K4 would mean?
> >>>
> >>> Thanks!
> >>>
> >>> JF
> >>>
> >>>
> >>> ______________________________________________________________________
> >>> This email has been scanned by the Symantec Email Security.cloud
> service.
> >>> For more information please contact helpdesk at x2960 or
> >>> [log in to unmask]
> >>> ______________________________________________________________________
> >>>
> >>
> >>
> >
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
>

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________